Grass Valley Ignite SDC - Manual (Page 75)

Ignite SDC/HDC Robotic Camera Instruction Manual 75
Menu Selections
Initial Settings
In case of the wrong setting in any use mode, take the following steps to
return to the initial settings.
1. Select [Initialize Data] on the main menu screen of each Use Mode.
Press the YES/ABC switch, then the [Initialize Data] screen (
Figure 47 )
shows for about 10 seconds.
Figure 47. initialize Data Screen
2. Press the YES/ABC switch within about 10 seconds to return to the
initial settings (
Table 30 and Table 31 ), the existing settings are
initialized ( Figure 48 ), and the camera returns to main menu.
Figure 48. Data Initialized Screen
3. If the NO/BAR switch is pressed, or if the YES/ABC switch is not
pressed, within about 10 seconds (
Figure 49 ), and the camera returns to
main menu, then the existing settings are not initialized.
Aspect Ratio Aspect ratio can be selected from 16:9 or 4:3.
Fan SW
OFF: Select this setting to stop the fan when its operating sound is found to
be bothersome in a studio or other such environment.
Auto: The temperature is detected automatically, and the fan starts operat-
ing when the temperature exceeds approx. 95 ºF (35 ºC)
Table 29. Other Settings
Selection Description
8492_39_r0
8492_40_r0