Grass Valley 3404 CopperHead - Manual (Page 75)

69
CopperHead 3404
User Guide
DIAG/REV REVF Indicates that the REV for the DISP board is REVF
DIAG/REV BASE Indicates the Base Station main microcontroller board is
revision is being queried
DIAG/REV REV Indicates that sub-mode is REV
DIAG/REV REVI Indicates that the REV for the BASE board is REVI
This display cycle repeats until the Display Mode Selector is pushed
DIAGNOSTIC MODE Camera Unit Error Status (CAM)
A quick push of the Display Mode Selector advances to the Camera Unit (CAM) diagnostic
sub-mode. This mode displays the error status of the Camera Unit. The Digital Display
Characters are Green if Camera Unit shows no error and Red if the Camera Unit does have
an error. This is a high-level view of the Camera Unit error status.
For further information go to the Camera Unit diagnostic display (see The CopperHead
3404 Base Station Digital Display on page 66).
DIAG/CAM CAM Indicates that the sub-mode is CAM
DIAG/CAM OK Indicates that the Camera Unit is reporting No fault
DIAG/CAM ERR Indicates that the Camera Unit is reporting Some fault
This display cycle repeats until the Display Mode Selector is pushed
Display Mode
Typical
Readout Base Station Digital Display Activity Explanation