Powering the system, Powering the copperhead 3404 base station, Powering the copperhead 3404 camera unit – Grass Valley 3404 CopperHead User Manual
Page 67
61
CopperHead 3404
User Guide
Powering the System
The CopperHead 3404 Base Station and the CopperHead 3404 Camera Unit each have a
power up routine which tests the equipment and performs a system diagnostic.
Powering the CopperHead 3404 Base Station
1 Base Station Main Power: Turn on the Base Station Power Mains Switch located at the
rear left (when facing the back of the Base Station) #3 on the overall diagram. This
switch is only on Base Station units with internal power. The front panel power light will
come on and displaysas Red until the next step.
2 Base Station Power: Turn on the Front Panel Power Switch located at the front right.
#16 on the overall diagram. The power monitor indicator turns from Red to Green.
3 Four-character Display LED Indicator progression: The four-character display
indicates TEST and all front panel LEDs turn, Red, then Green, then Orange, then OFF.
4 REV display: The LED color test is followed by REV and the revision of the display
microcontroller firmware.
5 Scrolling: The REV indication is followed by "www.miranda..com" scrolling across the
four-character display. If there's no scrolling please contact Grass Valley, a Belden Brand
support for assistance (see
6 PAUSE: The scroll is followed by about a 3 second interval used to synchronize all the
microcontrollers in the Base Station.
7 Diagnostics: The front panel will cycle through the diagnostics displays (see
CopperHead 3404 Base Station Digital Display
8 Current Status Displayed: After the 3 second pause, all the front panel displays update
with current status. If the Camera Unit is not powered on the camera related status
lights will displayas Red.
Powering the CopperHead 3404 Camera Unit
1 Camera Unit power: Turn on the Camera Unit Power Switch.
2 Camera Power: Turn on the Camera Power and also any peripheral equipment
connected to the camera or the CopperHead 3404 Camera Unit such as monitors and
microphones.
3 Four-character Display LED Indicator progression: On power on the four-character
display indicates the current Revision Version (REVA). Your unit will reflect the current
Revision Version. After the revision display the current Fiber Link strength is displayed.
A typical display is -8 to -13. This indicates Fiber link strength of from -8 to -13 dBm.
Both the Camera Unit and the Base Station have a digital display selector button which
allows multiple functions for the digital display. These functions are described below on