Grass Valley 3404 CopperHead - Manual (Page 43)

37
CopperHead 3404
User Guide
Up to 95 watts of power can be delivered to the camera, Camera Unit and camera powered
accessories. Up to 780 feet (240 meters) of cable can be used when the Camera Unit is
powered directly from the Base Station. Please ensure that the power provided is adequate
for the camera in use with your system.
The use of an external power supply can extend Base Station to Camera range and increase
camera power flexibility. The MPS "Throw Down" device or Wafer Power Adaptor provides
this functionality.
MPS External Power Wafer Power Supply
The CopperHead MPS external power supply provides 95 watts of 12VDC power and fiber
cable signal connectivity from the Base Station to the Camera. From the MPS unit to the
camera can be configured using either a Hybrid OpticalCON connector or a SMPTE 304M
connector. The length available is up to 780 feet or 240 meters.
From the MPS unit to the Base Station can be configured using a non-hybrid OpticalCON
connector or two ST connectors. The length available is up to 5 kilometers (3 miles).
The MPS is powered locally with standard AC power. The unit is free standing.
Fig. 4-28: MPS External Power Wafer Power Supply
All MPS Units require the Power Wafer to provide power to the Camera Unit. Four variations
are available with a different set of fiber cable connectors. All MPS units provide 95 watts of
12VDC power.
Part Number Fiber Connection to Camera
Fiber Connection to Base
Station
CH2-MPS-95VD-2ST-NEU OpticalCON 2 STs
CH2-MPS-95VD-2ST-304 SMPTE 304M 2 STs
CH2-MPS-95VD-NEU-NEU OpticalCON (with power) OpticalCON (no power)
CH2-MPS-95VD-NEU-304 SMPTE 304 (with power) OpticalCON (no power)