Grass Valley 3404 CopperHead User Manual
Page 59
53
CopperHead 3404
User Guide
Connectors into and out of the CopperHead 3404 Camera Unit Back Side
• 3: Intercom Headset Out
XLR 5 Pin Female Connector - Provides two channels of two-way intercom and the
Intercom Program audio feed.
• 4: Audio 1 & 2 Out
XLR 5 Pin Male Connector - Provides Return Audio Out from camera for Channels 1 & 2.
Typically connected to a local monitor at the camera position.
• 5: Audio 1 In
XLR 3 Pin Female Connector - Line level audio input. Typically fed by short audio
jumper cables from the Camera Audio 1 output (can also take local audio device feeds
from camera position).
• 6: Audio 2 In
XLR 3 Pin Female Connector - Line level audio input. Typically fed by short audio
jumper cables from the Camera Audio 2 output (can also take local audio device feeds
from camera position).
• 7: Camera Remote Connector
Multi-Pin Connector A - 10 Pin Hirose Connector. This is normally a Grass Valley, a
Belden Brand supplied cable. It connects the Camera Unit to the Camera CCU in to
allow operation of the Camera Remote Control Panel. Please see
on page 88 for a list of available cables.
Power to the Camera Unit & Camera must be turned off when connecting the Camera
Remote Control Panel Cable- connecting with the power on can seriously damage your
equipment.
• 8: Data Connector
Multi-Pin Connector B - DB15 15 Pin Serial Connector. This carries serial control signals
for lens and remote pan & tilt units as well as GPI, Intercom Trigger (GPI) and Tally
signals. Grass Valley, a Belden Brand supplies a number of pre-configured break out
cables for use with this connector (see
• 9: 4K- 3G/HD/SD SDI Inputs (4)
BNC Connectors - Carries 4K camera video from the Camera to the Camera Unit. This
requires BNC jumper cables between the Camera Unit and the Camera.
• 10: HD/SD SDI Input
BNC Connector - Carries camera video from the Camera to the Camera Unit. This
requires a short BNC jumper cable between the Camera Unit and the Camera.
• 11: HD/SD SDI Outputs #1 & #2
BNC Connector - Carries return video from the Base Station to the Camera Unit.
Typically this will feed a camera viewfinder or an HD viewing monitor at the camera
location.
• 12: VBS In
BNC Connector - Carries SD Analog video from the Camera to the Camera Unit. This
requires a short BNC jumper cable between the Camera Unit and the Camera. Can be
used to provide technical monitoring from camera as with superimposed camera
menus and other information.