Grass Valley Aurora Edit LD v.7.0 - Manual (Page 134)

You can use loop tones for voiceovers directly to the Timeline in case you make a
mistake and need to re-record.
1. Open the sequence where you want to add the narration.
2. Select the Source Tool by pressing 2 on your keyboard or clicking the Source
Tool button in the Timeline Toolbar.
3. If necessary, adjust the input levels to prevent overload at the input stage of the
source microphone.
4. Mark an In and Out point in your sequence where you want the voiceover to record.
5. If you want to continually record over the same point until you are satisfied with
the performance, click the Loop Record button to enable it.
6. If you want the system to display the remaining duration of the record, press the
Record Countdown button.
7. To start recording, press F12 on your keyboard or click the Start Recording
button.
8. To stop recording, press the spacebar on your keyboard or click the Stop
Recording button.
134 Aurora Edit LD User Guide 08 April 2010
Audio