Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual

Page 86

Configuration procedure

Step1

Configure IP addresses and unicast routing

Configure the IP address and subnet mask for each interface as per

. Detailed configuration

steps are omitted.
Configure OSPF for interconnection between the devices in the PIM-SM domain. Ensure the network-layer

interoperation among the devices, and ensure the dynamic update of routing information through a

unicast routing protocol. Detailed configuration steps are omitted.

Step2

8Enable IP multicast routing, and enable PIM-SM and IGMP

# Enable IP multicast routing on Device B, enable PIM-SM on each interface, and enable IGMP on the
host-side interface GigabitEthernet 1/1.

system-view

[DeviceB] multicast routing-enable

[DeviceB] interface gigabitethernet1/1

[DeviceB-GigabitEthernet1/1] igmp enable

[DeviceB-GigabitEthernet1/1] pim sm

[DeviceB-GigabitEthernet1/1] quit

[DeviceB] interface gigabitethernet 2/0

[DeviceB-GigabitEthernet2/0] pim sm

[DeviceB-GigabitEthernet2/0] quit

[DeviceB] interface gigabitethernet 3/0

[DeviceB-GigabitEthernet 3/0] pim sm

[DeviceB-GigabitEthernet 3/0] quit

[DeviceB] interface loopback 0

[DeviceB-LoopBack0] pim sm

[DeviceB-LoopBack0] quit

[DeviceB] interface loopback 10

[DeviceB-LoopBack10] pim sm

[DeviceB-LoopBack10] quit

[DeviceB] interface loopback 20

[DeviceB-LoopBack20] pim sm

[DeviceB-LoopBack20] quit

The configuration on Device A, Device C, Device D, and Device E is similar to the configuration on

Device B.

Step3

Configure C-BSRs and C-RPs

# Configure Loopback 10 as a C-BSR and configure Loopback 20 as a C-RP on Device B.

[DeviceB] pim

[DeviceB-pim] c-bsr loopback 10

[DeviceB-pim] c-rp loopback 20

[DeviceB-pim] quit

The configuration on Device D is similar to the configuration on Device B.

Step4

8Configure MSDP peers

This manual is related to the following products: