H3C Technologies H3C SecPath F1000-E - Manual (Page 42)

8
Configuring Basic Functions of IGMP
Configuration Prerequisites
Before configuring the basic functions of IGMP, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Configure PIM-DM or PIM-SM
Before configuring the basic functions of IGMP, prepare the following data:
• IGMP version
• Multicast group and multicast source addresses for static group member configuration
• ACL rule for multicast group filtering
• The maximum number of multicast groups that an interface can joined
Enabling IGMP
First, IGMP must be enabled on the interface on which the multicast group memberships are to be
established and maintained.
Follow these steps to enable IGMP on the public network:
To do... Use the command... Remarks
Enter system view system-view —
Enable IP multicast routing multicast routing-enable
Required
Disabled by default
Enter interface view
interface interface-type
interface-number
—
Enable IGMP igmp enable
Required
Disabled by default
NOTE:
For more information about the multicast routing-enable command, see Multicast Routing and Forwarding
Commands in the IP Multicast Volume.
Configuring IGMP Versions
Because the protocol packets of different IGMP versions vary in structure and type, you must configure the
same IGMP version for all routers on the same subnet before IGMP can work properly.
Configuring an IGMP version globally
Follow these steps to configure an IGMP version globally:
To do... Use the command... Remarks
Enter system view system-view —
Enter public network IGMP view igmp —