H3C Technologies H3C SecPath F1000-E - Manual (Page 180)

17
Configuring IPv6 PIM-SM
IPv6 PIM-SM Configuration Task List
Complete these tasks to configure IPv6 PIM-SM:
Task Remarks
Enabling IPv6 PIM-SM Required
Configuring a static RP Optional
Configuring a C-RP Optional
Enabling embedded RP Optional
Configuring an RP
Configuring C-RP timers globally Optional
Configuring a C-BSR Optional
Configuring an IPv6 PIM domain border Optional
Configuring C-BSR parameters globally Optional
Configuring C-BSR timers Optional
Configuring a BSR
Disabling BSM semantic fragmentation Optional
Enabling IPv6 administrative scoping Optional
Configuring an IPv6 admin-scope zone boundary Optional
Configuring IPv6
Administrative Scoping
Configuring C-BSRs for IPv6 admin-scope zones Optional
Configuring IPv6 Multicast Source Registration Optional
Configuring SPT Switchover Optional
Configuring IPv6 PIM Common Features Optional
Configuration Prerequisites
Before configuring IPv6 PIM-SM, complete the following task:
• Configure any IPv6 unicast routing protocol so that all devices in the domain are interoperable at
the network layer.
Before configuring IPv6 PIM-SM, prepare the following data:
• The IP address of a static RP and an ACL rule defining the range of IPv6 multicast groups to be
served by the static RP
• C-RP priority and an ACL rule defining the range of IPv6 multicast groups to be served by each C-RP
• A legal C-RP address range and an ACL rule defining the range of IPv6 multicast groups to be
served
• C-RP-Adv interval
• C-RP timeout
• C-BSR priority