H3C Technologies H3C SecPath F1000-E User Manual
Page 31
17
[DeviceA-ospf-1-area-0.0.0.0] network 20.1.1.0 0.0.0.255
[DeviceA-ospf-1-area-0.0.0.0] network 50.1.1.0 0.0.0.255
[DeviceA-ospf-1-area-0.0.0.0] quit
[DeviceA-ospf-1] quit
# Configure OSPF on Device B.
[DeviceB] ospf 1
[DeviceB-ospf-1] area 0
[DeviceB-ospf-1-area-0.0.0.0] network 20.1.1.0 0.0.0.255
[DeviceB-ospf-1-area-0.0.0.0] network 30.1.1.0 0.0.0.255
[DeviceB-ospf-1-area-0.0.0.0] quit
[DeviceB-ospf-1] quit
# Configure OSPF on Device C.
[DeviceC] ospf 1
[DeviceC-ospf-1] area 0
[DeviceC-ospf-1-area-0.0.0.0] network 30.1.1.0 0.0.0.255
[DeviceC-ospf-1-area-0.0.0.0] network 40.1.1.0 0.0.0.255
[DeviceC-ospf-1-area-0.0.0.0] network 50.1.1.0 0.0.0.255
[DeviceC-ospf-1-area-0.0.0.0] quit
[DeviceC-ospf-1] quit
Step4
8Enable IP multicast routing, PIM-DM, and IGMP.
# Enable multicast routing on Device A and enable PIM-DM on each interface.
[DeviceA] multicast routing-enable
[DeviceA] interface gigabitethernet 0/1
[DeviceA-GigabitEthernet0/1] pim dm
[DeviceA-GigabitEthernet0/1] quit
[DeviceA] interface gigabitethernet 0/2
[DeviceA-GigabitEthernet0/2] pim dm
[DeviceA-GigabitEthernet0/2] quit
[DeviceA] interface tunnel 0
[DeviceA-Tunnel0] pim dm
[DeviceA-Tunnel0] quit
# Enable multicast routing on Device C, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 0/1.
[DeviceC] multicast routing-enable
[DeviceC] interface gigabitethernet 0/1
[DeviceC-GigabitEthernet0/1] igmp enable
[DeviceC-GigabitEthernet0/1] pim dm
[DeviceC-GigabitEthernet0/1] quit
[DeviceC] interface gigabitethernet 0/2
[DeviceC-GigabitEthernet0/2] pim dm
[DeviceC-GigabitEthernet0/2] quit
[DeviceC] interface tunnel 0
[DeviceC-Tunnel0] pim dm
[DeviceC-Tunnel0] quit
Step5
Configure a static multicast route