H3C Technologies H3C SecPath F1000-E - Manual (Page 210)

47
[DeviceB-GigabitEthernet3/2] multicast ipv6 boundary scope 4
[DeviceB-GigabitEthernet3/2] quit
# On Device C, configure GigabitEthernet 3/1 and GigabitEthernet 3/2 as the boundary of IPv6
admin-scope zone 2.
system-view
[DeviceC] interface gigabitethernet 3/1
[DeviceC-GigabitEthernet3/1] multicast ipv6 boundary scope 4
[DeviceC-GigabitEthernet3/1] quit
[DeviceC] interface gigabitethernet 3/2
[DeviceC-GigabitEthernet3/2] multicast ipv6 boundary scope 4
[DeviceC-GigabitEthernet3/2] quit
# On Device D, configure GigabitEthernet 3/1 as the boundary of admin-scope zone 2.
system-view
[DeviceD] interface gigabitethernet 3/1
[DeviceD-GigabitEthernet3/1] multicast ipv6 boundary scope 4
[DeviceD-GigabitEthernet3/1] quit
Step4 Configure C-BSRs and C-RPs
# On Device B, configure the service scope of RP advertisements and configure GigabitEthernet 2/1 as
a C-BSR and C-RP of admin-scope zone 1.
[DeviceB] pim ipv6
[DeviceB-pim6] c-bsr scope 4
[DeviceB-pim6] c-bsr 1002::2
[DeviceB-pim6] c-rp 1002::2 scope 4
[DeviceB-pim6] quit
# On Device D, configure the service scope of RP advertisements and configure GigabitEthernet 2/1 as
a C-BSR and C-RP of admin-scope zone 2.
[DeviceD] pim ipv6
[DeviceD-pim6] c-bsr scope 4
[DeviceD-pim6] c-bsr 3002::2
[DeviceD-pim6] c-rp 3002::2 scope 4
[DeviceD-pim6] quit
# On Device F, configure GigabitEthernet 2/1 as a C-BSR and C-RP in the global scope zone.
system-view
[DeviceF] pim ipv6
[DeviceF-pim6] c-bsr scope global
[DeviceF-pim6] c-bsr 8001::1
[DeviceF-pim6] c-rp 8001::1
[DeviceF-pim6] quit
Step5 Verify the configuration
To view the BSR election information and the C-RP information on a device, use the display pim ipv6
bsr-info command. For example:
# View the BSR information and the locally configured C-RP information on Device B.
[DeviceB] display pim ipv6 bsr-info
Elected BSR Address: 8001::1
Priority: 64