H3C Technologies H3C SecPath F1000-E - Manual (Page 204)

41
[DeviceE-acl6-basic-2005] rule permit source ff0e::101 64
[DeviceE-acl6-basic-2005] quit
[DeviceE] pim ipv6
[DeviceE-pim6] c-bsr 1003::2 128 20
[DeviceE-pim6] c-rp 1003::2 group-policy 2005
[DeviceE-pim6] quit
Step4 Verify the configuration
Carry out the display pim ipv6 interface command to view the IPv6 PIM configuration and running
status on each interface. For example:
# Verify the IPv6 PIM configuration information on Device A.
[DeviceA] display pim ipv6 interface
Interface NbrCnt HelloInt DR-Pri DR-Address
GE1/1 0 30 1 1001::1
(local)
GE2/0 1 30 1 1002::2
GE3/0 1 30 1 1003::2
To view the BSR election information and the locally configured C-RP information in effect on a device,
use the display pim ipv6 bsr-info command. For example:
# View the BSR information and the locally configured C-RP information in effect on Device A.
[DeviceA] display pim ipv6 bsr-info
Elected BSR Address: 1003::2
Priority: 20
Hash mask length: 128
State: Accept Preferred
Uptime: 00:04:22
Expires: 00:01:46
# View the BSR information and the locally configured C-RP information in effect on Device D.
[DeviceD] display pim ipv6 bsr-info
Elected BSR Address: 1003::2
Priority: 20
Hash mask length: 128
State: Elected
Uptime: 00:05:26
Expires: 00:01:45
Candidate BSR Address: 4002::1
Priority: 10
Hash mask length: 128
State: Candidate
Candidate RP: 4002::1(GigabitEthernet3/0)
Priority: 192
HoldTime: 130
Advertisement Interval: 60
Next advertisement scheduled at: 00:00:48
# View the BSR information on Device E and the locally configured C-RP information in effect.
[DeviceE] display pim ipv6 bsr-info