H3C Technologies H3C SecPath F1000-E - Manual (Page 112)

16
To do... Use the command... Remarks
Configure the TTL value of state-refresh
messages
state-refresh-ttl ttl-value
Optional
255 by default
Configuring PIM-DM Graft Retry Period
In PIM-DM, graft is the only type of message that uses the acknowledgment mechanism. In a PIM-DM
domain, if a router does not receive a graft-ack message from the upstream router within the specified
time after it sends a graft message, the router keeps sending new graft messages at a configurable
interval, namely graft retry period, until it receives a graft-ack from the upstream router.
Follow these steps to configure graft retry period:
To do... Use the command... Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure graft retry period pim timer graft-retry interval
Optional
3 seconds by default
NOTE:
For more information about the configuration of other timers in PIM-DM, see Configuring PIM
Common Timers .
Configuring PIM-SM
PIM-SM Configuration Task List
Complete these tasks to configure PIM-SM:
Task Remarks
Configuring PIM-SM Required
Configuring a static RP Optional
Configuring a C-RP Optional
Enabling auto-RP Optional
Configuring an RP
Configuring C-RP timers globally Optional
Configuring a C-BSR Optional
Configuring a PIM domain border Optional
Configuring global C-BSR parameters Optional
Configuring C-BSR timers Optional
Configuring a BSR
Disabling BSM semantic fragmentation Optional
Configuring Administrative Scoping Enabling administrative scoping Optional