Cooling system failure – H3C Technologies H3C SR6600-X User Manual
Page 94
84
[H3C] save
Dealing with password loss when password recovery
capability is disabled
1.
Reboot the router to access the EXTEND-BOOTWARE menu, and enter 5.
The current mode is no password recovery.
Note: The current operating device is cfa0
Enter < Storage Device Operation > to select device.
===========================
|<1> Boot System |
|<2> Enter Serial SubMenu |
|<3> Enter Ethernet SubMenu |
|<4> File Control |
|<5> Restore to Factory Default Configuration |
|<6> Skip Current System Configuration |
|<7> BootWare Operation Menu |
|<8> Clear Super Password |
|<9> Storage Device Operation |
|<0> Reboot |
============================================================================
Ctrl+Z: Access EXTEND-ASSISTANT MENU
Ctrl+F: Format File System
Enter your choice(0-9): 5
2.
At the prompt for confirmation, enter Y.
The router deletes its main and backup next-startup configuration files and restores the
factory-default configuration.
The current mode is no password recovery. The configuration files will be
deleted, and the system will start up with factory defaults, Are you sure to
continue?[Y/N]Y
Setting...Done.
3.
When the EXTEND-BOOTWARE menu appears again, enter 0 to reboot the router.
The router starts up with the factory-default configuration.
4.
Configure a new console login password (see "
Configure a new console login password.
new user privilege level passwords (see "
Configure new passwords for user privilege levels.
5.
To make the settings take effect after a reboot, save the running configuration to the next-startup
configuration file.
[H3C] save
Cooling system failure
When the temperature inside the router exceeds the upper threshold, the following information appears
on the configuration terminal:
#Jun 14 11:54:38:178 2012 H3C DEVM/1/BOARD TEMPERATURE UPPER:
Trap 1.3.6.1.4.1.25506.8.35.12.1.16