H3C Technologies H3C SR6600-X - Manual (Page 117)

107
Item Remarks
Memory type and size
• Default—One 2-GB DDR3 SDRAM
• Maximum—Two 2-GB DDR3 SDRAMs
NVRAM 128 KB
Combo interface
2
2 copper ports (MDI/MDIX
autosensing)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
2 fiber ports 1000 Mbps, full-duplex
MIM 4 supported
HIM
2 full-height or 4 half-height HIMs supported
(Half-height HIMs include HIM-4G4P, HIM-TS8P, and HIM-8GBP-V2.)
Hardware encryption Supported
Hot swapping Supported
NOTE:
•
For a combo interface, the default operating port is the copper port. You can use either the copper port
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
see H3C SR6600/SR6600-X Routers Interface Command Reference.
• Use transceiver modules for the fiber ports provided by H3C only. The router might be incompatible with
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-240 combo interface specifications
Specification of combo interfaces on the FIP-240 and the FIP-110 are the same. For more information,
see Table 33 and Table 34 .
Transceiver modules available for the FIP-240 fiber ports are the same. For more information, see Table
35 .
Maximum interface modules provided by FIP-240 in full configuration
FIP/Interface module SR6604-X SR6608-X SR6616-X
FIP-240 2 4 8
MIM 8 16 32
HIM 4 (8 half-height HIMs) 8 (16 half-height HIMs) 16 (32 half-height HIMs)
FIP-300
The FIP-300 supports HIMs and MIMs, and it provides 12 combo interfaces.