H3C Technologies H3C SR6600-X - Manual (Page 28)

18
Figure 15 Installing a HIM
Installing a MIM
The procedures for installing MIMs are similar. This example installs a MIM to a FIP-210.
To install a MIM:
1. Face the front of the router and locate the slot to install the MIM on the FIP-210.
The MIM should be installed in the lower slot on the FIP-210.
2. Loosen the captive screws with a Phillips screwdriver to remove the filler panel from the slot.
Keep the removed filler panel for future use.
3. Holding the handle of the MIM with one hand, push the MIM slowly along the slide rails into the
slot until the MIM is fully seated.
4. Use a flat-blade screwdriver to fasten the captive screws on the MIM.
Figure 16 Pushing the MIM into the slot