H3C Technologies H3C SR6600-X - Manual (Page 127)

117
Table 40 Transceiver modules for the SAP-4EXP 10G Ethernet ports
Model
Central
wavelength Connector Optical
fiber
Max. transmission
distance
SFP-XG-SX-MM850-
A
850 nm LC
50/125 μm multi-mode
optical fiber
300 m (984.25 ft)
SFP-XG-LX-SM1310 1310 nm LC
9/125 μm single-mode
optical fiber
10 km (6.21 miles)
SFP-XG-LH40-SM15
50
1550 nm LC
9/125 μm single-mode
optical fiber
40 km (24.86 miles)
NOTE:
•
Use transceiver modules provided by H3C only. The router might be incompatible with other transceiver
modules.
• 1000 Mbps is not supported on the SAP-4EXP SFP+ ports.
• To support the wire-speed forwarding cross board on the SAP-4EXP, the SR6616-X router needs to be
installed with a SFE-X1.
SPE/OAP
H3C SR6604-X, SR6608-X, and SR6616-X routers support the service processing engine (SPE). Based on
the open application platform (OAP), the SPE can provide multiple services. For more information about
the SPE and OAP, see relevant datasheet.
HIM/MIM
H3C SR6604-X, SR6608-X, and SR6616-X routers support HIMs and MIMs. Both HIMs and MIMs
provide synchronous serial ports, Ethernet ports and E1 ports. For more information, see H3C
SR6600/SR6600-X Routers Interface Module Guide.
Lightning protector for a port
If part of the network cable of a copper Ethernet port must be routed outdoors, connect a lightning
protector to the cable before you plug the cable into the port.
You can install the following port lightning protectors to the router:
Type Port description
Maximum discharge current
(8/20μs waveform)
Output voltage
10 Mbps/100 Mbps
port lightning
protector
Single port 2.5 KA
• Core-core ≤ 15 V
• Core-ground ≤ 300 V
1000 Mbps port
lightning protector
Single port 3 KA
• Core-core ≤ 15 V
• Core-ground ≤ 350 V