H3C Technologies H3C SR6600-X - Manual (Page 27)

17
3. Gently push the FIP-210 into the slot along the slide rails until positioning pins on the backplane
are seated in the positioning holes, and then push the ejector levers inward to lock the FIP-210 in
position.
4. Use a Phillips screwdriver to fasten the captive screws on the two sides of the FIP-210.
For more information about the FIP LED description, see " FIP LEDs ."
Figure 14 Inserting a FIP
Installing a HIM
Before the installation, make sure the ejector levers of the HIM are outwards.
The procedures for installing HIMs are similar. This example installs a HIM to a FIP-210.
To install a HIM:
1. Face the front of the router and locate the slot to install the HIM on the FIP-210.
A HIM occupies two slots of the FIP.
2. Loosen the captive screws with a Phillips screwdriver to remove the filler panel.
Keep the removed filler panel for future use.
3. Push the HIM slowly along the slide rails into the slot, and then pull the levers inward to lock the
HIM in position.
4. Use a Phillips screwdriver to fasten the captive screws on the HIM.