H3C Technologies H3C SR6600-X - Manual (Page 118)

108
FIP-300 front panel
Figure 99 FIP-300 front panel
(1) HIM/MIM slot (2) GE0 through GE11 copper ports
(3) GE0 through GE11 fiber ports
FIP-300 specifications
Item Remarks
Flash 8 MB
Memory type and size
• Default—Two 2-GB DDR3 SDRAMs
• Maximum—Two 2-GB DDR3 SDRAMs
NVRAM 128 KB
Combo interface
12
Copper ports (MDI/MDIX
autosensing)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
Fiber ports 1000 Mbps, full-duplex
HIM 1 supported
MIM 1 supported
Hardware encryption Supported
Hot swapping Supported
NOTE:
•
For a combo interface, the default operating port is the copper port. You can use either the copper port
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
see H3C SR6600/SR6600-X Routers Interface Command Reference.
• Use transceiver modules for the fiber ports provided by H3C only. The router might be incompatible with
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-300 combo interface specifications
Specification of combo interfaces on the FIP-300 is the same as FIP-110. For more information, see Table
33 and Table 34 .
Transceiver modules for the FIP-300 are the same as the FIP-110. For more information, see Table 35 .