H3C Technologies H3C SR6600-X - Manual (Page 26)

16
Figure 13 Installing an SFE-X1
Installing an LPU
CAUTION:
The RUN LED flashes fast when the FIP is starting up. Do not install or remove a HIM/MIM during this
period. Otherwise, hardware might be damaged.
Slot 3 of the SR6604-X/SR6608-X and Slot 7 of the SR6616-X are not provided with filler panels.
Before the installation, make sure the ejector levers of the LPU are outwards.
The procedures for installing LPUs are similar. This section uses a FIP-210 as an example.
To install a FIP-210:
1. Face the front of the router and locate the slot to be used.
2. Loosen the captive screws with a Phillips screwdriver to remove the filler panel from the slot.
Keep the removed filler panel for future use.
Skip this step if you install the FIP-210 to Slot 3 of the SR6604-X/SR6608-X, or Slot 7 of the
SR6616-X.