H3C Technologies H3C SR6600-X - Manual (Page 49)

39
2. The other end of the cable provides eight RJ-45 connectors. Connect them to the RJ-45 interface on
the remote device as needed.
Figure 45 Connecting an 8T1 cable
Connecting a CE3/CT3 cable
Overview
H3C recommends that you install a special lightning protector at the input end of the E3/T3 cables to
protect them against lightning strikes more efficiently when they are routed outdoors.
You can use an E3/T3 interface cable to connect the MIM-1CE3 and MIM-1CT3 modules.
Figure 46 E3/T3 cable
Connecting a CE3/CT3 cable
1. Connect the SMB connector of an E3/T3 cable to the Tx port on the interface module and the other
end to the Rx port on the device to be connected.
2. Connect the SMB connector of another E3/T3 cable to the Rx port of interface module and the
other end to the Tx port on the device to be connected.