H3C Technologies H3C SR6600 - Manual (Page 50)

42
• Use the reboot command to reboot a router.
• Enable the scheduled reboot function at the CLI. You can set a time at which the router can
automatically reboot, or set a delay so that the router can automatically reboot within the delay.
• Power on the router after powering it off, which is also called hard reboot or cold start. Powering off
a running router causes data loss and hardware damages, and therefore is not recommended.
Perform the following operation to reboot the router immediately:
To do… Use the command… Remarks
Reboot the router immediately reboot
Required
Available in user view
Perform the following operation to enable the scheduled reboot function:
To do… Use the command… Remarks
Enable the scheduled reboot
function and specify a specific
reboot time and date
schedule reboot at hh:mm [ date ]
Enable the scheduled reboot
function and specify a reboot
waiting time
schedule reboot delay { hh:mm |
mm }
Use either command
The scheduled reboot function is
disabled by default.
Available in user view
CAUTION:
•
If the main startup configuration file does not exist, do not use the reboot command to reboot the router.
In this case, you should specify the main startup configuration file first, and then reboot the router.
• The precision of the rebooting timer is 1 minute. One minute before the rebooting time, the router
prompts “REBOOT IN ONE MINUTE” and reboots in one minute.
• If you are performing file operations when the router is to be rebooted, the system does not execute the
reboot command for security.