H3C Technologies H3C SR6600 - Manual (Page 26)

18
Figure 18 Remove the dust cover
Step2 Plug one end of the optical fiber into the transceiver module in the switch, as shown in Figure 19 .
Figure 19 Install the transceiver module
Step3 Remove the dust cover on the transceiver module.
Step4 Plug the LC connectors on one end of the fiber cable into the Rx and Tx ports, and plug the LC connectors
on the other end to the Tx and Rx ports on the peer device, as shown in
Figure 20 .
Figure 20 Connect the fiber connectors
Step5 Check whether the LEDs of the optical interfaces are normal. For more information about the LED status,
see “ Appendix B LEDs .”