Installing a him, Installing a mim – H3C Technologies H3C SR6600 User Manual
Page 23
15
NOTE:
Keep the removed filler panel and screws for future use.
Installing a HIM
Follow these steps to install a HIM:
Step1
Select the slot to install the HIM, and remove the filler panels on the slot. For how to remove a filler panel,
see “
Step2
Push the HIM slowly along the slide rails into the slot, and then pull the levers inward.
Figure 15 Install a HIM
Step3
Use a flat-blade screwdriver to fasten the captive screws on the HIM.
Step4
Power on the router and check the status LED on the front panel. On means the HIM is installed correctly
and running properly. Off means the HIM has failed the POST.
NOTE:
HIMs are hot swappable and you must perform the remove slot
number command to stop the module
before you remove it.
Installing a MIM
A MIM can be installed only at the bottom of slot 1 or slot 2.
Follow these steps to install a MIM:
Step1
Select the slot to install the MIM, and remove the filler panels on the slot. For how to remove a filler panel,
see “
Step2
Push the MIM slowly along the slide rails into the slot, and then pull the levers inward.