H3C Technologies H3C SR6600 - Manual (Page 32)

24
Figure 24 Connect an AC power cord to the router
Connecting an RPS DC power cord
NOTE:
No RPS power cord is provided with the router. Prepare it yourself.
RPS power receptacle
The RPS power receptacle locates at the front panel, as shown in Figure 25 .
Figure 25 RPS power receptacle
Follow these steps to connect an RPS DC power cord:
Step1 Make sure that the router and the RPS power switch are off.
Step2 Remove the adhesive tape from the protection cover of the RPS power supply.
Step3 Loosen the captive screws on the RPS receptacle protection cover and remove the protection cover from
the router, as shown in
Figure 26 .