H3C Technologies H3C SR8800 - Manual (Page 70)

61
Task Command Remarks
Display VRRP group status.
display vrrp [ verbose ] [ interface
interface-type interface-number
[ vrid virtual-router-id ] ] [ | { begin
| exclude | include }
regular-expression ]
Available in any view
Display VRRP group statistics.
display vrrp statistics [ interface
interface-type interface-number
[ vrid virtual-router-id ] ] [ | { begin
| exclude | include }
regular-expression ]
Available in any view
Clear VRRP group statistics.
reset vrrp statistics [ interface
interface-type interface-number
[ vrid virtual-router-id ] ]
Available in user view
Configuring VRRP for IPv6
VRRP for IPv6 configuration task list
Complete these tasks to configure VRRP for IPv6:
Task Remarks
Configuring a VRRP working mode Optional
Specifying the type of MAC addresses mapped to virtual IPv6
addresses
Optional
When VRRP works in load balancing
mode, this configuration is not
effective.
Creating a VRRP group and configuring a virtual IPv6 address Required
Configuring router priority, preemptive mode and tracking function Optional
Configuring VF tracking
Optional
The VF tracking function is effective
only when VRRP works in load
balancing mode.
Configuring VRRP packet attributes Optional
Specifying the type of MAC addresses mapped to virtual IPv6
addresses
After you specify the type of MAC addresses mapped to the virtual IPv6 address of VRRP groups and
create a VRRP group, the master in the VRRP group uses the specified type of MAC address as the source
MAC address for sending packets and uses the specified type of MAC address to answer ND requests
from hosts so that the hosts in the internal network can learn the mapping between the IPv6 address and
the MAC address.