H3C Technologies H3C SR8800 - Manual (Page 25)

16
Task Command Remarks
Display the statistics on Ethernet
OAM link error events after an
Ethernet OAM connection is
established.
display oam link-event { local | remote }
[ interface interface-type interface-number ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display the information about an
Ethernet OAM connection.
display oam { local | remote } [ interface
interface-type interface-number ] [ | { begin |
exclude | include } regular-expression ]
Available in any view
Clear statistics on Ethernet OAM
packets and Ethernet OAM link
error events.
reset oam [ interface interface-type
interface-number ] Available in user view
only
Ethernet OAM configuration example
Network requirements
On the network shown in Figure 2 , perform the following operations:
• Enable Ethernet OAM on Router A and Router B to auto-detect link errors between the two routers.
• Monitor the performance of the link between Router A and Router B by collecting statistics about the
error frames received by Router A.
Figure 2 Network diagram
Configuration procedure
1. Configure Router A:
# Configure GigabitEthernet 4/1/2 to operate in passive Ethernet OAM mode and enable
Ethernet OAM for it.
system-view
[RouterA] interface GigabitEthernet 4/1/2
[RouterA-GigabitEthernet4/1/2] oam mode passive
[RouterA-GigabitEthernet4/1/2] oam enable
[RouterA-GigabitEthernet4/1/2] quit
# Set the errored frame detection interval to 20 seconds and set the errored frame event triggering
threshold to 10.
[RouterA] oam errored-frame period 20
[RouterA] oam errored-frame threshold 10
2. Configure Router B: