H3C Technologies H3C SR8800 - Manual (Page 115)

106
• Track. For more information, see the chapter “Configuring track.”
• IP fast reroute (FRR). Currently, IP FRR is supported by OSPF, RIP, IS-IS and static routing. For more
information, see Layer 3—IP Routing Configuration Guide.
Protocols and standards
• draft-ietf-bfd-base-09, Protocol Independent Bidirectional Forwarding Detection
• draft-ietf-bfd-v4v6-1hop-10, BFD for IPv4 and IPv6 (Single Hop)
• draft-ietf-bfd-multihop-08, BFD for Multihop Paths
• draft-ietf-bfd-generic-05, Generic Application of BFD
Configuring BFD basic functions
The BFD basic function configuration is the basis for configuring BFD for other protocols.
Configuration prerequisites
Before configuring BFD basic functions, complete the following tasks:
• Configure the network layer addresses of the interfaces so that adjacent nodes are reachable to
each other at the network layer
• Configure the routing protocols that support BFD
Configuration procedure
To configure BFD basic functions:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Specify the mode for
establishing a BFD session. bfd session init-mode
{ active | passive }
Optional.
active by default.
3. Configure the destination port
number for multi-hop BFD
control packets.
bfd multi-hop
destination-port
port-number
Optional.
4784 by default.
4. Configure the source IP
address of echo packets. bfd echo-source-ip
ip-address
Optional.
The source IP address should not
be on the same network segment
as any local interface’s IP address.
Otherwise, a large number of
ICMP redirect packets may be sent
from the peer, resulting in link
congestion.
5. Enter interface view.
interface
interface-type
interface-number
N/A