H3C Technologies H3C S5560 Series Switches - Manual (Page 96)

81
Configuring an interface to use BOOTP for IP
address acquisition
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an interface to use
BOOTP for IP address acquisition. ip address bootp-alloc
By default, an interface does not
use BOOTP for IP address
acquisition.
Displaying and maintaining BOOTP client
Execute display command in any view.
Task Command
Display BOOTP client information.
display bootp client [ interface interface-type
interface-number ]
BOOTP client configuration example
Network requirements
As shown in Figure 17 , Switch B's port belonging to VLAN 10 is connected to the LAN. VLAN-interface
10 obtains an IP address from the DHCP server by using BOOTP.
To make the BOOTP client obtain an IP address from the DHCP server, you must perform configurations
on the DHCP server. For more information, see " DHCP server configuration examples ."
Configuration procedure
The following describes the configuration on Switch B, which acts as a client.
# Configure VLAN-interface 10 to dynamically obtain an IP address from the DHCP server.
system-view
[SwitchB] interface vlan-interface 10
[SwitchB-Vlan-interface10] ip address bootp-alloc
Verifying the configuration
# Display the IP address assigned to the BOOTP client.
[SwitchB] display bootp client