Load sharing configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S5560 Series Switches User Manual
Page 132
117
Load sharing configuration example
Network requirements
As shown in
, Switch A has two equal-cost routes to Switch B. Configure load sharing on Switch
A to forward packets through Switch B to the destination IP address 1.2.3.4/24.
Figure 49 Network diagram
Configuration procedure
# On Switch A, assign GigabitEthernet 1/0/5 to VLAN 10, and GigabitEthernet 1/0/6 to VLAN 20.
[SwitchA] vlan 10
[SwitchA-vlan10] port GigabitEthernet 1/0/5
[SwitchA-vlan10] quit
[SwitchA] vlan 20
[SwitchA-vlan20] port GigabitEthernet 1/0/6
[SwitchA-vlan20] quit
# On Switch A, configure IP addresses for VLAN-interface 10 and VLAN-interface 20.
[SwitchA] interface vlan-interface 10
[SwitchA-Vlan-interface10] ip address 10.1.1.1 24
[SwitchA-Vlan-interface10] quit
[SwitchA] interface vlan-interface 20
[SwitchA-Vlan-interface20] ip address 20.1.1.1 24
[SwitchA-Vlan-interface20] quit
# On Switch B, assign GigabitEthernet 1/0/5 to VLAN 10, and GigabitEthernet 1/0/6 to VLAN 20.
[SwitchB] vlan 10
[SwitchB-vlan10] port GigabitEthernet 1/0/5
[SwitchB-vlan10] quit
[SwitchB] vlan 20
[SwitchB-vlan20] port GigabitEthernet 1/0/6
[SwitchB-vlan20] quit
# On Switch B, configure IP addresses for VLAN-interface 10 and VLAN-interface 20.
[SwitchB] interface vlan-interface 10
[SwitchB-Vlan-interface10] ip address 10.1.1.2 24
[SwitchB-Vlan-interface10] quit
[SwitchB] interface vlan-interface 20
[SwitchB-Vlan-interface20] ip address 20.1.1.2 24
[SwitchB-Vlan-interface20] quit