H3C Technologies H3C S5560 Series Switches - Manual (Page 23)

8
Configuration examples
Static ARP configuration example
Network requirements
As shown in Figure 3 , hosts are connected to the switch. The switch is connected to the router through
interface GigabitEthernet 1/0/1 in VLAN 10.
To ensure secure communications between the router and switch, configure a static ARP entry for the
router on the switch.
Figure 3 Network diagram
Configuration procedure
# Create VLAN 10.
system-view
[Switch] vlan 10
[Switch-vlan10] quit
# Add interface GigabitEthernet 1/0/1 to VLAN 10.
[Switch] interface GigabitEthernet 1/0/1
[Switch-GigabitEthernet1/0/1] port access vlan 10
[Switch-GigabitEthernet1/0/1] quit
# Create VLAN-interface 10 and configure its IP address.
[Switch] interface vlan-interface 10
[Switch-vlan-interface10] ip address 192.168.1.2 8
[Switch-vlan-interface10] quit
# Configure a static ARP entry that has IP address 192.168.1.1, MAC address 00e0-fc01-0000, and
output interface GigabitEthernet 1/0/1 in VLAN 10.
[Switch] arp static 192.168.1.1 00e0-fc01-0000 10 GigabitEthernet 1/0/1
# Display information about static ARP entries.
[Switch] display arp static
Type: S-Static D-Dynamic O-Openflow M-Multiport I-Invalid