H3C Technologies H3C S5560 Series Switches User Manual

Page 239

224

[SwitchA-Vlan-interface101] ip address 2.1.1.1 255.255.255.0

[SwitchA-Vlan-interface101] quit

# Create service loopback group 1 and specify its service type as tunnel.

[SwitchA] service-loopback group 1 type tunnel

# Assign GigabitEthernet 1/0/3 to service loopback group 1.

[SwitchA] interface GigabitEthernet 1/0/3

[SwitchA-GigabitEthernet1/0/3] port service-loopback group 1

[SwitchA-GigabitEthernet1/0/3] quit

# Create the IPv4 over IPv4 tunnel interface Tunnel 1.

[SwitchA] interface tunnel 1 mode ipv4-ipv4

# Specify an IPv4 address for the tunnel interface.

[SwitchA-Tunnel1] ip address 10.1.2.1 255.255.255.0

# Specify the IP address of VLAN-interface 101 as the source address for the tunnel interface.

[SwitchA-Tunnel1] source 2.1.1.1

# Specify the IP address of VLAN-interface 101 on Switch B as the destination address for the

tunnel interface.

[SwitchA-Tunnel1] destination 3.1.1.1

[SwitchA-Tunnel1] quit

# Configure a static route destined for the IPv4 group 2 through the tunnel interface.

[SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 1

Configure Switch B:
# Specify an IPv4 address for VLAN-interface 100.

system-view

[SwitchB] interface vlan-interface 100

[SwitchB-Vlan-interface100] ip address 10.1.3.1 255.255.255.0

[SwitchB-Vlan-interface100] quit

# Specify an IPv4 address for VLAN-interface 101, which is the physical interface of the tunnel.

[SwitchB] interface vlan-interface 101

[SwitchB-Vlan-interface101] ip address 3.1.1.1 255.255.255.0

[SwitchB-Vlan-interface101] quit

# Create service loopback group 1 and specify its service type as tunnel.

[SwitchB] service-loopback group 1 type tunnel

# Assign GigabitEthernet 1/0/3 to service loopback group 1.

[SwitchB] interface GigabitEthernet 1/0/3

[SwitchB-GigabitEthernet1/0/3] port service-loopback group 1

[SwitchB-GigabitEthernet1/0/3] quit

# Create the IPv4 over IPv4 tunnel interface Tunnel 2.

[SwitchB] interface tunnel 2 mode ipv4-ipv4

# Specify an IPv4 address for the tunnel interface.

[SwitchB-Tunnel2] ip address 10.1.2.2 255.255.255.0

# Specify the IP address of VLAN-interface 101 as the source address for the tunnel interface.

[SwitchB-Tunnel2] source 3.1.1.1

# Specify the IP address of VLAN-interface 101 on Switch A as the destination address for the

tunnel interface.

[SwitchB-Tunnel2] destination 2.1.1.1

This manual is related to the following products: