beautypg.com

Configuring an isatap tunnel – H3C Technologies H3C S5560 Series Switches User Manual

Page 234

background image

219

Reply from 2002:501:101:1::2: bytes=32 time<1ms

Ping statistics for 2002:501:101:1::2:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milli-seconds:

Minimum = 0ms, Maximum = 13ms, Average = 3ms

Configuring an ISATAP tunnel

Follow these guidelines when you configure an ISATAP tunnel:

You do not need to configure a destination address for an ISATAP tunnel, because the destination
IPv4 address is embedded in the ISATAP address.

Because automatic tunnels do not support dynamic routing, configure a static route destined for the

destination IPv6 network at each tunnel end. You can specify the local tunnel interface as the egress
interface of the route or specify the IPv6 address of the peer tunnel interface as the next hop of the

route. For more information about route configuration, see Layer 3—IP Routing Configuration

Guide.

The source addresses of local tunnels of the same tunnel mode cannot be the same.

To configure an ISATAP tunnel:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter ISATAP tunnel interface view. interface tunnel number [ mode

ipv6-ipv4 isatap ]

N/A

3.

Specify an IPv6 address for the

tunnel interface.

See "

Configuring basic IPv6

settings

."

By default, no IPv6 address is
configured for the tunnel
interface.

4.

Configure a source address or

source interface for the tunnel
interface.

source { ip-address |
interface-type interface-number }

By default, no source address
or source interface is

configured for the tunnel

interface.
The specified source address or
the primary IP address of the

specified source interface is

used as the source IP address of

tunneled packets.

5.

(Optional.) Set the DF bit for
tunneled packets.

tunnel dfbit enable

By default, the DF bit is not set
for tunneled packets.

6.

Return to system view.

quit

N/A

7.

(Optional.) Enable dropping of
IPv6 packets using

IPv4-compatible IPv6 addresses.

tunnel discard
ipv4-compatible-packet

By default, this feature is
disabled.

This manual is related to the following products: