H3C Technologies H3C S5800 Series Switches - Manual (Page 71)

61
Connecting the PSR150-D/PSR150-D1 to a –54 VDC output
RPS
1. Unpack the RPS power cord, identify the plug for connecting to the power module, correctly orient
the plug with the power receptacle on the power module, and insert the plug into the receptacle
(see callout 1 in Figure 65 ). The receptacle is foolproof. If you cannot insert the plug into the
receptacle, re-orient the plug rather than use excessive force to push it in.
2. Tighten the screws on the plug with a flat-blade screwdriver to secure the plug in the power
receptacle (see callout 2 in
Figure 65 ).
3. Connect the other end of the power cord to the RPS.
Connecting the PSR300-12A/PSR300-12A1/PSR300-12A2
1. Check that the AC power module is off.
2. Pull the bail latch upwards (see Figure 66 ).
3. Connect one end of the AC power cord supplied with the power module to the power receptacle
on the power module (see callout 1 in
Figure 67 ).
4. Pull the bail latch down to secure the plug in the power receptacle (see callout 2 in Figure 67 ).
5. Connect the other end of the power cord to an AC power outlet.
Figure 66 Connect an AC power cord to the PSR300-12A/PSR300-12A1/PSR300-12A2 (I)