H3C Technologies H3C S5800 Series Switches - Manual (Page 26)

16
NOTE:
USB devices from different vendors vary in compatibility and driver. H3C does not guarantee correct
operation of USB devices from other vendors on the switch. If a USB device does not operate correctly on
the switch, replace it with one from another vendor.
10/100/1000Base-T Ethernet port
Every S5800 switch except the S5800-32F has 10/100/1000Base-T Ethernet ports.
Table 6 10/100/1000Base-T Ethernet port specifications
Item Specification
Connector type RJ-45
Interface attributes
• 10 Mbps, full duplex
• 100 Mbps, full duplex
• 1000 Mbps, full duplex
• MDI/MDI-X, auto-sensing
Max transmission distance 100 m (328.08 ft)
Transmission medium Category-5 (or above) twisted pair cable
Standards IEEE 802.3i, 802.3u, 802.3ab
100/1000Base-X SFP port
The S5800-60C-PWR and S5800-32F switches have 100/1000Base-X SFP ports, and you can install
the 100 Mbps or 1000 Mbps SFP transceiver modules in
Table 7 in the ports.
Table 7 100/1000Base-X SFP transceiver modules available for the H3C S5800 Switch Series
Transceiver module
Central
wavelength Connector Fiber
Max transmission
distance
1000 Mbps transceiver modules
SFP-GE-SX-MM850-A 850 nm LC
• 50/125 μm
multimode optical
fiber
• 62.5/125 μm
multimode optical
fiber
• 550 m (1804.46 ft)
over 50/125 μm
fiber
• 275 m (902.23 ft)
over 62.5/125 μm
fiber
SFP-GE-LX-SM1310-A 1310 nm LC
9/125 μm single mode
optical fiber
10 km (6.21 miles)
SFP-GE-LH40-SM1310 1310 nm LC
9/125 μm single mode
optical fiber
40 km (24.86 miles)
SFP-GE-LH40-SM1550 1550 nm LC
9/125 μm single mode
optical fiber
40 km (24.86 miles)