H3C Technologies H3C S5800 Series Switches - Manual (Page 27)

17
Transceiver module
Central
wavelength Connector Fiber
Max transmission
distance
SFP-GE-LH70-SM1550 1550 nm LC
9/125 μm single mode
optical fiber
70 km (43.50 miles)
SFP-GE-T N/A RJ-45 Category-5 twisted pair 100 m (328.08 ft)
100 Mbps transceiver modules
SFP-FE-SX-MM1310-A 1310 nm LC
62.5/125 μm
multimode optical fiber 2 km (1.24 miles)
SFP-FE-LX-SM1310-A 1310 nm LC
9/125 μm single mode
optical fiber
15 km (9.32 miles)
SFP-FE-LH40-SM1310 1310 nm LC
9/125 μm single mode
optical fiber
40 km (24.86 miles)
SFP-FE-LH80-SM1550 1550 nm LC
9/125 μm single mode
optical fiber
80 km (49.71 miles)
NOTE:
•
To guarantee the functionality of the SFP ports, use only H3C SFP transceiver modules on the H3C
S5800 Switch Series.
• The SFP transceiver modules available for this switch series are subject to change over time. For the most
up-to-date list of SFP transceiver modules, consult your H3C sales representative or technical support
engineer.
• For the SFP transceiver module specifications, see H3C Low End Series Ethernet Switches Pluggable
Modules Manual.
SFP+ port
Every S5800 switch (except the S5800-60C-PWR) has fixed SFP+ ports, and you can plug the SFP+
transceiver modules, SFP transceiver modules, and SFP+ cables in Table 8 into the SFP ports as needed.
You can use the SFP+ ports as IRF physical ports to connect S5800 switches in an IRF deployment.
Table 8 SFP+ transceiver modules and cables available for the H3C S5800 Switch Series
Transceiver
module/cable
Central
wavelength
Connector Fiber
Max transmission
distance
1000 Mbps SFP transceiver modules
SFP-GE-SX-MM850-A 850 nm LC
• 50/125 μm
multimode optical
fiber
• 62.5/125 μm
multimode optical
fiber
• 550 m (1804.46 ft)
over 50/125 μm
fiber
• 275 m (902.23 ft)
over 62.5/125 μm
fiber
SFP-GE-LX-SM1310-A 1310 nm LC
9/125 μm single
mode optical fiber
10 km (6.21 miles)
SFP-GE-LH40-SM1310 1310 nm LC
9/125 μm single
mode optical fiber
40 km (24.86 miles)