H3C Technologies H3C S5800 Series Switches User Manual
Installation manual
Table of contents
Document Outline
- Title Page
- Preface
- Content
- Product overview
- About the H3C S5800 Switch Series
- Switch models and technical specifications
- Hardware compatibility matrix
- S5800-60C-PWR panel views
- S5800-56C panel views
- S5800-56C-PWR panel views
- S5800-54S panel views
- S5800-32C panel views
- S5800-32C-PWR panel views
- S5800-32F panel views
- Ports
- LEDs
- Hot swappable power modules
- Hot swappable fan trays
- Interface cards
- OAP cards
- Hot swappable PoE modules
- Preparing for installation
- Installing the switch
- Installing the switch in a 19-inch rack
- Installation methods
- Mounting bracket and cable management bracket kits
- Rack mounting rail kit
- Installing the mounting brackets, chassis rails, and grounding cable (for the S5800-54S)
- Attaching the mounting brackets to the switch chassis (for all S5800 switches except the S5800-54S)
- Rack-mounting the S5800-54S switch
- Rack-mounting an S5800 switch except the S5800-54S
- Mounting the switch on a workbench
- Grounding the switch
- Installing/Removing a fan tray
- Installing/Removing a power module
- Connecting the power cord
- Connecting an AC power cord to the switch
- Connecting the switch to a –54 VDC output RPS
- Connecting the switch to a 12 VDC output RPS
- Connecting the PSR150-A/PSR150-A1
- Connecting the PSR150-D/PSR150-D1 to a –48 VDC power source
- Connecting the PSR150-D/PSR150-D1 to a –54 VDC output RPS
- Connecting the PSR300-12A/PSR300-12A1/PSR300-12A2
- Connecting the PSR300-12D1/PSR300-12D2 to a –48 VDC power source
- Connecting the PSR300-12D1/PSR300-12D2 to a –54 VDC output RPS
- Connecting the PSR750-A
- Connecting the PSR750-D to a –54 VDC output RPS
- Connecting the LSVM1AC650/LSVM1AC300
- Connecting the LSVM1DC650/LSVM1DC300
- Installing/Removing an interface card
- Installing/Removing an OAP card
- Installing an OAP card in the OAP card slot (only for the S5800-60C-PWR)
- Removing the card in the OAP card slot (only for the S5800-60C-PWR)
- Installing an OAP card in an expansion interface card slot (for the entire series but the S5800-54S)
- Removing the OAP card in an expansion interface card slot (for the entire series but the S5800-54S)
- Installing/Removing a PoE module
- Verifying the installation
- Installing the switch in a 19-inch rack
- Powering on the switch for the first time
- Setting up an IRF fabric
- IRF fabric setup flowchart
- Planning IRF fabric setup
- Configuring basic IRF settings
- Connecting the physical IRF ports
- Accessing the IRF fabric to verify the configuration
- Maintenance and troubleshooting
- Index