H3C Technologies H3C S5800 Series Switches - Manual (Page 44)

34
Installing the switch in a 19-inch rack
Installation methods
You can install the H3C S5800 Switch Series in a 19-inch rack by using load-bearing mounting brackets,
as shown in Figure 22 , Figure 23 , and Figure 24 .
Figure 22 Install an S5800-60C-PWR switch in a 19-inch rack
Figure 23 Install an S5800-54S switch in a 19-inch rack
Figure 24 Install other models of the H3C S5800 Switch Series in a 19-inch rack
NOTE:
If a rack shelf is available, you can put the switch on the rack shelf, slide the switch to an appropriate
location, and fix the switch to the rack with mounting brackets.
Table 30 Install an S5800-54S switch in the rack
Mounting bracket position Installing the
mounting brackets
Installing the chassis rails
and slide rails
Installing the
switch
• Rear mounting (near the
power modules)
• Front mounting (near the
network ports)
See " Attaching the
mounting brackets
and chassis rails to
the switch chassis
."
Required.
See "
Attaching the mounting
brackets and chassis rails to the
switch chassis " and Attaching
the slide rails to the rack
See " Installing the
switch in the rack ."
CAUTION:
The depth of the rack for the S5800-54S switch must be 1000 mm (39.37 in).