H3C Technologies H3C S5800 Series Switches - Manual (Page 57)

47
Figure 41 Connect the grounding cable to the grounding hole of switch
(1) Chassis rear panel (2) Grounding sign
(3) Grounding hole (4) OT terminal
(5) Grounding cable (6) Grounding screw
To attach the other end of the grounding cable to the grounding strip:
1. Cut the grounding cable as appropriate for connecting to the grounding strip.
2. Peel 5 mm (0.20 in) of insulation sheath by using a wire stripper, and insert the bare metal part
through the black insulation covering into the end of the OT terminal. (The switch comes with two
OT terminals. Select the OT terminal appropriate to the size of the grounding post.)
3. Secure the metal part of the cable to the OT terminal with a crimper, cover the joint with the
insulation covering, and heat the insulation covering with a blow dryer to completely cover the
metal part.
4. Connect the OT terminal to the grounding pole of the grounding strip, and fasten it with a hex nut.
Figure 42 Connect the grounding cable to a grounding strip
(1) Grounding post (2) Grounding strip
(3) Grounding cable (4) Hex nut