H3C Technologies H3C S5800 Series Switches - Manual (Page 62)

52
Figure 50 Install a power filler module
Removing a power module
CAUTION:
If the switch has two power modules, removing one power module does not affect the operation of the
switch. If the switch has only one power module, removing the power module powers off the switch.
To remove an LSVM1AC650, LSVM1DC650, LSVM1AC300, or LSVM1DC300 power module from the
S5800-54S switch:
1. Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
grounded.
2. Squeeze the tabs on the power cord connector with your thumb and forefinger, and pull the
connector out to remove the power cord, as shown in
Figure 51 .
3. Hold the handle on the power module with one hand, pivot the latch on the power module to the
right with your thumb, and pull the power module part way out of the slot. Then supporting the
power module bottom with one hand, slowly pull the power module out with the other hand, as
shown in
Figure 52 .