H3C Technologies H3C S5800 Series Switches - Manual (Page 30)

20
LED mark Status Description
Flashing yellow (1 Hz) Some ports have failed to pass POST.
Off The switch is powered off.
Power module LED
Each power module slot has a status LED to show how the hot swappable power module in the slot is
operating.
Table 11 Power module status LED description
LED mark Status Description
PWR1
Steady green
A power module is installed in power module slot 1, and the power output
is normal.
Steady yellow
A power module is installed in power module slot 1, but the power module
has an output problem.
Off
No power module is installed in power module slot 1, or no power is being
input.
PWR2
Steady green
A power module is installed in power module slot 2, and the power output
is normal.
Steady yellow
A power module is installed in power module slot 2, but the power module
has an output problem.
Off No power module is installed in power module slot 2, or no power is input.
RPS status LED
The RPS status LED shows the status of the RPS DC input.
Table 12 describes the RPS status LED behaviors for the S5800-32C and S5800-56C switches.
Table 13 describes the RPS status LED behaviors for the S5800-32C-PWR and S5800-56C-PWR
switches.
Table 12 S5800-32C and S5800-56C RPS status LED description
LED mark Status Description
RPS
Steady green
Both the RPS DC input and the AC input are normal, or an RPS is connected
and the AC input is normal.
Steady yellow The RPS DC input is normal, but the AC input is disconnected or has failed.
Off No RPS is connected.
Table 13 S5800-32C-PWR and S5800-56C-PWR RPS status LED description
LED mark Status Description
RPS Steady green Both the RPS DC input and the AC input are normal.