H3C Technologies H3C S5800 Series Switches - Manual (Page 34)

24
Table 19 SFP+ port LED description
Port mode LED
(Mode) status
SFP+ port LED status Description
Steady green
(rate mode)
Steady green
The port is operating at 10 Gbps. The port LED fast flashes
when the port is sending or receiving data.
Steady yellow
The port is operating at 1 Gbps. The port LED fast flashes when
the port is sending or receiving data.
Flashing yellow (3 Hz) POST has failed on the port.
Off No link is present on the port.
Steady yellow
(duplex mode)
Steady green
The port is operating in full duplex mode. The port LED fast
flashes when the port is sending or receiving data.
Flashing yellow (3 Hz) POST has failed on the port.
Off No link is present on the port.
Management Ethernet port LEDs
The S5800-32F and S5800-54S switches have two management Ethernet port LEDs (LINK and ACT).
Table 20 Management Ethernet port LEDs description
LED mark Status Description
LINK
Off The management Ethernet port is not connected.
Steady green The management Ethernet port is operating at 10/100/1000 Mbps.
ACT
Off The management Ethernet port is not receiving or sending data.
Flashing yellow The management Ethernet port is sending or receiving data.
OAP card status LED
The SLOT3 LED on the front panel of the S5800-60C-PWR switch shows the status of the card in the OAP
card slot.
Table 21 OAP card status LED description
LED mark Status Description
SLOT3
Green An OAP card is in the slot and operating correctly.
Flashing yellow (1 Hz)
The slot does not support the OAP card model, or the OAP card
has failed.
Off The OAP card slot is empty.
PoE module status LED
The S5800-60C-PWR switch has a PoE module status LED (SLOT4) on its front panel.