H3C Technologies H3C S5800 Series Switches - Manual (Page 56)

46
Figure 40 Connect the grounding cable to a grounding strip
(1) Hex nut (2) OT terminal
(3) Grounding post (4) Grounding strip
NOTE:
•
H3C recommends that you use the primary grounding point or auxiliary grounding point 1 because the
grounding cable and grounding screw provided with the switch are applicable only to these two
grounding points.
• To use auxiliary grounding point 2, you must prepare a grounding cable yourself.
Connecting the grounding cable for an S5800 switch except the S5800-54S
All S5800 switches except the S5800-54S switch have a grounding point (with a grounding sign) on
their rear panels.
To connect the grounding cable:
1. Remove the grounding screw from the rear panel of the switch chassis.
2. Attach the grounding screw to the OT terminal of the grounding cable.
3. Use a screwdriver to fasten the grounding screw into the grounding screw hole.