H3C Technologies H3C S10500 Series Switches - Manual (Page 8)

7
CAUTION:
•
To prevent configuration loss, save the latest configuration changes before you reboot the switch.
• For more information about the boot-loader command, see the Fundamentals Command Reference in
the H3C S10500 Switch Series Command References.
3. Install the patch package
# Install the patch package S10500R1120Patch001.bin, and configure the device to continue the
installation after reboot.
system-view
[Sysname] patch install file S10500R1120Patch001.bin
Patches will be installed. Continue? [Y/N]:y
Do you want to run patches after reboot? [Y/N]:y
Installing patches…
NOTE:
If a patch package was installed before, you must uninstall it before you can install the new one. To view
patch information, use the display patch information command. For details about patch installation, see
Fundamentals Configuration Guide in the H3C S10500 Switch Series Configuration Guides.
Upgrading an IRF fabric
Upgrade prerequisites
# Telnet to the switch or log in through the console port.
# Display device information.
display device
Chassis Slot Type State Subslot Soft Ver Patch Ver
1 0 LSU1SUPA Master 0 S10500 P001
1 1 LSU1SUPA Slave 0 S10500 P001
1 2 LSU1GP24TXSE Normal 0 S10500 P001
1 3 LSU1TGX4SE Normal 0 S10500 P001
1 4 NONE Absent 0 NONE None
1 5 NONE Absent 0 NONE None
1 6 LSU1FAB04A Normal 0 S10500 P001
1 7 NONE Absent 0 NONE None
1 8 NONE Absent 0 NONE None
1 9 NONE Absent 0 NONE None
2 0 LSU1SUPA Slave 0 S10500 P001
2 1 LSU1SUPA Slave 0 S10500 P001
2 2 LSU1GP24TXSE Normal 0 S10500 P001
2 3 LSU1TGX4SE Normal 0 S10500 P001
2 4 NONE Absent 0 NONE None
2 5 NONE Absent 0 NONE None
2 6 LSU1FAB04A Normal 0 S10500 P001
2 7 NONE Absent 0 NONE None
2 8 NONE Absent 0 NONE None
2 9 NONE Absent 0 NONE None