H3C Technologies H3C S10500 Series Switches - Manual (Page 37)

36
|5 31911744 Apr/06/2000 17:23:33 M s10500.bin |
|6 4 Apr/10/2000 22:11:31 N/A snmpboots |
|7 9176 Apr/11/2000 17:44:02 N/A patch.bin |
|8 1526 Apr/02/2000 01:02:50 N/A patchstate |
|9 5844 Apr/11/2000 22:09:07 N/A test/my_archive_1.cfg |
|10 118773 Apr/11/2000 21:17:30 N/A logfile.log |
|0 Exit |
============================================================================
Enter file No:
Step2 Type the number of the target file. For example, type 9, and the following information appears.
The file you selected is flash:/test/my_archive_1.cfg,Delete it? [Y/N]
Step3 Type Y to delete the selected file. The following information appears.
Deleting.....Done!
Handling upgrade failures
If an upgrade failure occurs, the switch operates using the original version.
To handle upgrade failure:
1. Check that physical ports are correctly connected.
2. Check that the HyperTerminal settings are correct.
3. Check the HyperTerminal output for errors. The following shows some possible errors.
• You have selected a baud rate other than 9600 bps, but did not set to the corresponding baud rate
on HyperTerminal.
• You typed an incorrect TFTP server IP address, filename, or directory.
• You typed an incorrect FTP server IP address, filename, file directory, FTP username, or password.
4. Verify that FTP or TFTP server software is running and has correct settings.
5. Verify that the flash has enough memory to store the downloaded files.
6. Verify that the versions of system software and BootWare are correct. For the compatibility
between the system software and BootWare, see the hardware and software compatibility matrix
in Release Notes.
7. Verify that the BootWare image is applicable to the target cards.
8. If a message “Something is wrong with the file” appears, check that the file is usable.
Copyright © 2011-2012 Hangzhou H3C Technologies Co., Ltd.