Upgrading bootware – H3C Technologies H3C S10500 Series Switches User Manual
Page 25
24
Figure 6 Send the file using XMODEM
When the download is complete, the following information appears:
Download successfully!
31911808 bytes downloaded!
Input the File Name:update.bin
Updating File flash:/update.bin..............................................
.....................................................Done!
===========================
|Note:the operating device is flash |
|<1> Download Application Program To SDRAM And Run |
|<2> Update Main Application File |
|<3> Update Backup Application File |
|<4> Update Secure Application File |
|<5> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-5):
Step12
Type 0 to return to the BooWare menu, and type 1 in the BootWare menu to boot the switch.
NOTE:
•
After the startup, change the baud rate of the HyperTerminal back to 9600 bps by following Step 5
through Step 7.
•
H3C recommends you to use the management Ethernet port to download the system software image for
a higher speed.
Upgrading BootWare
Upgrade the BootWare program from the BootWare menu by using one of the following methods:
•