H3C Technologies H3C S10500 Series Switches User Manual
Page 7
6
This command will update bootrom file on the specified board(s),
Continue? [Y/N]:y
Now updating bootrom, please wait...
Start accessing bootflash chip...
Bootrom update succeeded in slot 1.
# Upgrade the BootWare for the LPU in slot 3 (upgrade other LPUs in the same way).
This command will update bootrom file on the specified board(s),
Continue? [Y/N]:y
Now updating bootrom, please wait...
Board has finished loading file on Chassis 0 Slot 3.
Start accessing bootflash chip...
Bootrom update succeeded in slot 3.
# Upgrade the BootWare for the switching fabric module in slot 6.
This command will update bootrom file on the specified board(s),
Continue? [Y/N]:y
Now updating bootrom, please wait...
Board has finished loading file on Chassis 0 Slot 6.
Start accessing bootflash chip...
Bootrom update succeeded in slot 6.
# Reboot the switch to validate the upgrade.
Start to check configuration with next startup configuration file, please wait.
........DONE!
This command will reboot the device. Continue? [Y/N]:y
Reboot device by command.
2.
Upgrade system software
# Specify the file newest.bin as the main system software image to be used at the next startup of the
active MPU in slot 0.
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 0!
# Specify the file newest.bin as the main system software image to be used at the next startup of the
standby MPU in slot 1.
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 1!
# Reboot the switch to validate the upgrade.
Start to check configuration with next startup configuration file, please wait.
........DONE!
This command will reboot the device. Continue? [Y/N]:y
Reboot device by command.