Using tftp through the management ethernet port – H3C Technologies H3C S10500 Series Switches User Manual
Page 26
25
•
Using FTP through the management Ethernet port
•
Using Xmodem through the console port
Using TFTP through the management Ethernet port
Step1
Connect the management Ethernet port of the switch to the PC that stores the target BootWare image
(a .btw file) (the IP address of the PC is required), and connect the console port of the switch to the same
or another PC.
Step2
Run the TFTP server program on the PC connected to the management Ethernet port and specify the file
storage directory.
NOTE:
S10500 switches are not shipped with TFTP server software. Prepare it by yourself.
Step3
Run the terminal emulation program on the PC connected to the console port. Start the switch, enter the
BootWare menu (see
for more information), and type 7 when you see "Enter your
choice(0-9):" to enter the BootWare operation menu.
=========================
|Note:the operating device is flash |
|<1> Backup Full BootWare |
|<2> Restore Full BootWare |
|<3> Update BootWare By Serial |
|<4> Update BootWare By Ethernet |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):
Step4
Type 4 to enter Ethernet submenu.
===================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):
Step5
Type 4 to set Ethernet port parameters.
NOTE:
•
If no parameters are set, pressing Enter adopts the default settings.
•
You only need to configure settings under
======================
|Note: '.' = Clear field. |
| '-' = Go to previous field. |
| Ctrl+D = Quit. |