Using ftp through the management ethernet port – H3C Technologies H3C S10500 Series Switches User Manual

Page 28

Updating Extend BootWare? [Y/N]

Step9

Type Y to upgrade extended BootWare. After the upgrade is complete, the following information

appears.

Updating Extend BootWare.........Done!

======================================

|<1> Update Full BootWare |

|<2> Update Extend BootWare |

|<3> Update Basic BootWare |

|<4> Modify Ethernet Parameter |

|<0> Exit To Main Menu |

============================================================================

Enter your choice(0-4):

Step10

Type 0 to return to the BootWare operation menu, and type 0 in the BootWare operation menu to return
to the BootWare menu.

Step11

Type 0 in the BootWare menu to reboot the switch.

Using FTP through the management Ethernet port

Step1

Connect the management Ethernet port of the switch to the PC that stores the target BootWare image

(a .btw file) (the IP address of the PC is required), and connect the console port of the switch to the same

or another PC.

Step2

Run the FTP server program on the PC connected to the management Ethernet port, specify the file
storage directory, and set the username and password.

NOTE:

S10500 switches are not shipped with FTP server software. Prepare it by yourself.

Step3

Run the terminal emulation program on the PC connected to the console port. Start the switch, enter the

BootWare menu (see

BootWare menu

for more information), and press 7 when you see "Enter your

choice(0-9):" to enter the BootWare operation menu.

===================================================

|Note:the operating device is flash |

|<1> Backup Full BootWare |

|<2> Restore Full BootWare |

|<3> Update BootWare By Serial |

|<4> Update BootWare By Ethernet |