H3C Technologies H3C S10500 Series Switches User Manual
Page 31
30
|<4> Update BootWare By Ethernet |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):
Step3
Type 3 to enter serial submenu.
====================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-4):
Step4
Type 4 to modify the serial port baud rate.
===============================
|Note:'*'indicates the current baudrate |
| Change The HyperTerminal's Baudrate Accordingly |
|---------------------------
|<1> 9600(Default)* |
|<2> 19200 |
|<3> 38400 |
|<4> 57600 |
|<5> 115200 |
|<0> Exit |
============================================================================
Enter your choice(0-5):2
Step5
Select a baud rate as need. For example, type 2 to select 19200 bps, and the following information
appears.
Baudrate has been changed to 19200 bps.
Please change the terminal's baudrate to 19200 bps, press ENTER when ready.
NOTE:
If you select the baud rate of 9600 bps, directly go to Step 9.
Step6
Disconnect the HyperTerminal from the switch by selecting Call/Disconnect in the HyperTerminal
window.
Figure 7 Disconnect the terminal
Step7
Select File > Properties in the HyperTerminal window, click Configure in the popup dialog box, and
select the baud rate of 19200 bps in the console port properties dialog box.